PRODUCTION OF ELECTRO PORCELAIN REINFORCED WITH BORIC ACID AND INVESTIGATION OF ITS PROPERTIES

Basit Öğe Kaydı
dc.contributor.authorBilgin, Aziz Emre
dc.contributor.authorGokmese, Hakan
dc.contributor.authorBostan, Bulent
dc.date.accessioned2024-02-23T14:48:39Z
dc.date.available2024-02-23T14:48:39Z
dc.date.issued2015
dc.departmentNEÜen_US
dc.description.abstractThe need of electrical energy is raised by the development of industry and that required to transportation of energy to the more distant points. All these developments reveal the need of cheaper insulator production and the need of enhancement of insulators' technical specifications and mechanical resistance against the increasing mains voltage and external factors. In the study, three different prescriptions, contain 0.1 %, 0.3 % and 1% H3BO3 additive, were prepared. Then, prepared samples were shaped on vacuum presses in the laboratory. After samples were dried, they were sintered at 1255 degrees C for 2 hours in air. Particle size distribution, dry refinement, fuchsine and bending three point tests were applied to the samples. Characterizations of microstructure were performed by XRD, SEM and EDS analyses. At the end of the experimental studies, it was seen that depending on additive percentage, the reduction of particle size distribution is up to 0.3% and particle size is increasing with an increase in additive ratio. The maximum dry reduction amount was seen on the sample that contains 1 % boric acid. In general, it was determined that the sample, which contains 0.3 % boric acid, gives closer results to operation conditions. Therefore, it was observed that the boric acid could be an alternative raw material source, if it is incorporate into electro-ceramic at a certain ratio.en_US
dc.identifier.endpage583en_US
dc.identifier.issn1300-1884
dc.identifier.issn1304-4915
dc.identifier.issue4en_US
dc.identifier.scopusqualityQ2en_US
dc.identifier.startpage577en_US
dc.identifier.urihttps://hdl.handle.net/20.500.12452/17750
dc.identifier.volume30en_US
dc.identifier.wosWOS:000368517800004en_US
dc.identifier.wosqualityQ4en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isotren_US
dc.publisherGazi Univ, Fac Engineering Architectureen_US
dc.relation.ispartofJournal Of The Faculty Of Engineering And Architecture Of Gazi Universityen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectElectro Porcelainen_US
dc.subjectBoric Aciden_US
dc.subjectSinteringen_US
dc.titlePRODUCTION OF ELECTRO PORCELAIN REINFORCED WITH BORIC ACID AND INVESTIGATION OF ITS PROPERTIESen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu